Eagletree Systems MicroVector Servo Adapter Board

$ 12.00

This board is engineered for breaking out the servo connections of an Eagletree Systems MicroVector. The servo +5 and GND rails are common and not connected to the +5v of the MicroVector. You must connect a BEC (possible in an ESC) to the rail to power connected servos. GND/+5V connector at the bottom of the board is +5V and GND from the MicroVector. J3 header is common with the servo +5V and GND rails. This can be used for a discreet BEC. Board includes pre-soldered SH connector and loose 6x3 right angle header.

 

  • Due to a error in manufacturing, the including wiring harness is reversed. As a courtesy, this harness will be provided at no additional charge.